TECHNOELAST MOST S

Application areas

Waterproofing of bridgeworks, ramps, floats and other structures.

Method of application

The material is welded on a prepared surface using a gas burner or special-purpose equipment. Material application: according to the Manual for Waterproofing of Bridgeworks by Roll-Fed Welded-On TECHNOELASTMOST Materials.

Description of material

TECHNOELASTMOST S is a waterproofing material produced by placing a special binder on a superstrong base. The material has maximum indicators for wear resistance, durability and withstands high temperatures (up to +220°C).

TECHNOELASTMOST S is widely recognized as a reliable material for waterproofi ng installation at federal transport facilities.

TECHNOELASTMOST S is designed for installation of the protective and coupling layer on steel orthotropic reinforced concrete slabs for traffi c ways in case of asphalt concrete installation (up to +220°C) directly on waterproofing.

TECHNOELASTMOST can be used in all climatic zones (as determined in Construction Codes and Regulation (SNiP) 23-01-99*).

Storage

  • Store vertically, in a place protected from direct sunlight.
  • Thickness 5.2 mm
  • Waterproofing warranty — 10 years
  • Service life — more than 40 years

Specifications

Property   TECHNOELASTMOST S
Thickness, mm (±0.1 mm)   5,2 
Mass of 1 m2, kg, (±0.25 kg)   5,8 
Longitudinal/transverse breaking load, N, not less than  polyester  1000/900 
Bend point on R=25 mm and R=10 mm beam, °C, no more than   -25 
Heat endurance, °С, not less than   140 
Static puncture resistance, N, not less than   250 
Protective covering type  on the top  sand 
on welded-on side  film with logo 
Length / width, m   8х1 

TECHNOELAST MOST S

Technical Data Sheet (TDS)

blog