TECHNOELAST FLAME STOP

Application areas

Waterproofing of roofs with more stringent requirements for fire safety.

Method of application

The material is welded on a prepared surface using a gas burner. Material application: according to the Manual for Designing and Installation of Roofs Made of Polymer-Bitumen Materials Manufactured by the TechnoNICOL Corporation.

for quotation For Buy: +880 1711 464779

Description of material

Technoelast FLAME STOP is a material for arranging the top layer of roof cladding. Due to the unique polymer-bitumen mixture with special components (fire-retardants) , Technoelast FLAME STOP offers enhanced fire-fighting performance. According to Construction Codes and Regulations (SNiP) 21.01, the material has the following parameters: — flame spread group RP1 (does not spread fl ames); — inflammability group V2 (moderately infl ammable). Technoelast FLAME STOP can be used in all climatic zones (as determined in Construction Codes and Regulation (SNiP) 23-01-99*).

Storage

Store vertically, in a place protected from direct sunlight.
Waterproofing warranty — 10 years
Service life — 25-30 years

Specifications:

Property		Technoelast FLAME STOP
Thickness, mm (±0.1 mm)		4,2
Mass of 1 m2, kg, (±0.25 kg)		5,2
Longitudinal/transverse breaking load, N, not less than	polyester	600/400
Bend point on R=25 mm and R=10 mm beam, °C, no more than		-25
Heat endurance, °С, not less than		100
Fireproofing parameters		RP1 and V2
Protective covering type	on the top	slate
Protective covering type	on welded-on side	film with logo
Length / width, m		10х1